Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

0

Replacing Roll-restrictor mounts

Started by rkctdwn, Sep 07 2010 12:09 PM

Please log in to reply

2 replies to this topic

#1 rkctdwn

Member

Members
363 posts

Location:Lucas, Ohio n40 42.438 w82 25.604
Interests:Grandsons, Amateur radio, Military aircraft esp.(f111), thanking those who served for our freedom and honoring those who gave their all, self training OBD II, self training GPS/DGPS surveying, stewardship of my land ("semi-tree hugger"), trying to follow/understand our energy problem and doing my part with solar doemstic hot water and my new Geo-thermal heat pump, trying to maintain my stuff in this ^&%*&%$ throw away culture-----enough for the moment! Alias F111D F
Vehicle owned:
98 Mystique LS (07/97)

Posted 07 September 2010 - 12:09 PM

First is it even possible to even replace the firewall engine mount with ATX still installed? I'm reading Ford CD-well sure glad I'm not Ford mechanic-whoever wrote this left too much to the imagination!!!
Does anyone have the Powertrain alignment tool-would appreciate the measurement of distance from the base to the center of the bolt hole.

Is this normal for front mount to wear out before firewall mount?
Thanks any info will help!!!
Paul

Attached Files

PADalign.rtf 42.86K 18 downloads

Back to top

#2 flatlander665

Junior Member

Members
10 posts

Vehicle owned:
1998 Contour SE

Posted 30 January 2011 - 02:24 PM

rkctdwn, on 07 September 2010 - 12:09 PM, said:

First is it even possible to even replace the firewall engine mount with ATX still installed? I'm reading Ford CD-well sure glad I'm not Ford mechanic-whoever wrote this left too much to the imagination!!!
Does anyone have the Powertrain alignment tool-would appreciate the measurement of distance from the base to the center of the bolt hole.

Is this normal for front mount to wear out before firewall mount?
Thanks any info will help!!!
Paul

I am wondering the same thing. I have purchased the forward and rear trans mounts. However, the rear trans mount (firewall side) looks impossible to get to from above and below without removing something. I can't seem to find any useful pictures or instructions on this forum for removing and replacing the rear (firewall side) trans mount.

Back to top

#3 spridget

I eat fried rice.

Moderators
2,465 posts

Gender:Male
Location:Deep in the Heart of Texas
Interests:driving fast
Vehicle owned:
1999 SVT

Posted 05 February 2011 - 11:41 PM

I've never worked on an ATX model, but it seems common for either mount to fail. The front seems weaker in general to me. I've never used the alignment tool either. I just use a jack and/or pry bar to center the mount in the bracket before torqueing the through bolt.