jovan915

I will try but you cant really see it its between spark plug wires and pcv and those are above it . Do you know where to buy the part ford doesnt make the part anymore

Is that a engine mount ?

Its near the fire wall the mount that needs to be changed

Not sure my Mechanic he told me the one in the back is broken he said its was a engine mount he just fixed the front one when my car is in reverse car shakes or when I go up to 20-mph moter makes a click noise and u feel when gear changes .. its auto

Trying to get it replaced my back motor mount is broken if its called that and not sure how to get to it have a ford contour se 2.5 need help

we spraid brake fluid on top of the engine where the manifold gasket was I heard a rattling noise

no the original owner (im the second) just left his car sitting and used it only in the city got it at 42,000 rightnow its 82,000 had it for 3 years this past year iv been replacing all the parts that needed it. my mechanic sprayed around the top of the engine with brake fluid we heard a weird noise, right now we here hissing noises, im going to use incents and see if there is a leak before we take the tom part of the engine is there a vacume hose the runs there?

getting the code doesn't wanna go off I replace the bad pcv hose tighten everything around the air box and on the engine disconnected the battery to reset it when I fixed it no luck any ideas

my car has 79000 miles needs a tune up nothing was ever done on the car

Yaj it sounds like a difficult job ill just pay someone to do it

what's the best way to be done iv never done it

have ford contour se not sure how you do it and what is the best way

I guess idk how my new starter fried some how the cable on it that attaches on it burned a hole into it so I got new one since there was a life time warranty on it

gasket needs to be changed never done it going to try it tom what are the best steps and advice to do it for my contour se

ya was the gasket

i put a k&n filter on and i disconnected things on the filter box and took it out to put on the air filter gasket after that was running ok but was starting really slow as if the battery was low on juice and continued with my day and i turned it on and it didn't wanna turn on i checked the sensors and the mass air flow sensor wasn't clipped on all the way so did it disconnected the battery and reconnected it started up and was fine today in the morning started it up was doing the same things was starting slow and lights dimmed a little took it to work and later today didn't turn on again tried to do the same thing with the battery and it didn't work so i disconnected it longer and tried it again and no luck i tried jumping it wasn't the battery i bought a new mass flow sensor and connected it and tried again no luck so now i left it connected and battery disconnected to try it later to day any ideas

Ok ill check it out its been like this for a while like 2 last year but they put something on the bolt to stop it

so idk why or how but there is oil constantly dripping from the bolt area where u unscrew it to drain oil iv tighten it already I had like something on my other screw they put on when I got a oil change on my car but had to change it now idk what to do I put some silent around it and it didn't work. what will help solve this problem

I hear it like on the passenger side when I put the car in drive and slowly drive its always at slow speeds I hear it the most or when im parked and I turn the wheel left or right continuously I hear it to when I drive in a enclosed area I hear it as I accelerate it

at the end of the night I drive home its 30 min drive when I drive from 0-10 mile I here clicking noise I checked oil its good kind of worried everyone says these engines brake down a lot

first is when I am accelerating between 0-8 starts making noises I think its coming from the passenger side I hear it when I start to drive it also makes the noise when I turn my steering wheel to the left and right continuously just for a second when im on parking my car runs great 72,000 on it previous owner never changed anything it has a broken engine mount on top but doesn't make the noise from that I usually feel the engine move when it gets to 20 miles any ideas second is im flushing my brake fluid and power steering haven been changed probably since it was in the dealer just want to know whats the best oils to use for my car.. I heard that transmission oil works good as power steering fluid?

I just use the recommended one and buy it in the bottles not at oil change places I heard there oil is cheap and the ones u buy in the bottle are better quality I plan on getting the motor craft double . what do you mean the nut behind the wheel

its ok np

terry im not sure what ur last message ment I just started learning about cars. my car is a ford contour se 2.5 let me know if it is compatible

So the motor caft are recommend double platinum .. how much for the k&n